10ge2p1x710-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr.robot revision d68951ac
1# Copyright (c) 2019 Cisco and/or its affiliates.
2# Licensed under the Apache License, Version 2.0 (the "License");
3# you may not use this file except in compliance with the License.
4# You may obtain a copy of the License at:
5#
6#     http://www.apache.org/licenses/LICENSE-2.0
7#
8# Unless required by applicable law or agreed to in writing, software
9# distributed under the License is distributed on an "AS IS" BASIS,
10# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
11# See the License for the specific language governing permissions and
12# limitations under the License.
13
14*** Settings ***
15| Resource | resources/libraries/robot/shared/default.robot
16|
17| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
18| ... | NIC_Intel-X710 | ETH | IP4FWD | BASE | VHOST | 1VM | VHOST_1024
19| ... | NF_TESTPMD | DRV_VFIO_PCI
20|
21| Suite Setup | Setup suite single link | performance
22| Suite Teardown | Tear down suite | performance
23| Test Setup | Setup test
24| Test Teardown | Tear down test | performance | vhost
25|
26| Test Template | Local Template
27|
28| Documentation | *RFC2544: Pkt throughput IPv4 test cases with vhost*
29|
30| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
31| ... | with single links between nodes.
32| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
33| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
34| ... | routing and two static IPv4 /24 route entries. Qemu VNFs are \
35| ... | connected to VPP via vhost-user interfaces. Guest is running testpmd \
36| ... | interconnecting vhost-user interfaces, rxd/txd=1024. DUT1/DUT2 is \
37| ... | tested with ${nic_name}.
38| ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
39| ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
40| ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
41| ... | of packets transmitted. NDR and PDR are discovered for different\
42| ... | Ethernet L2 frame sizes using MLRsearch library.\
43| ... | Test packets are generated by TG on links to DUTs. TG traffic profile
44| ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
45| ... | flow-group) with all packets containing Ethernet header, IPv4 header
46| ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
47| ... | addresses of the TG node interfaces.
48| ... | *[Ref] Applicable standard specifications:* RFC2544.
49
50*** Variables ***
51| @{plugins_to_enable}= | dpdk_plugin.so
52| ${crypto_type}= | ${None}
53| ${nic_name}= | Intel-X710
54| ${nic_driver}= | vfio-pci
55| ${osi_layer}= | L3
56| ${overhead}= | ${0}
57| ${nf_dtcr}= | ${1}
58| ${nf_dtc}= | ${1}
59| ${nf_chains}= | ${1}
60| ${nf_nodes}= | ${1}
61# Traffic profile:
62| ${traffic_profile}= | trex-sl-3n-ethip4-ip4src253
63
64*** Keywords ***
65| Local Template
66| | [Documentation]
67| | ... | [Cfg] DUT runs IPv4 routing config.
68| | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
69| | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
70| |
71| | ... | *Arguments:*
72| | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
73| | ... | Type: integer, string
74| | ... | - phy_cores - Number of physical cores. Type: integer
75| | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
76| |
77| | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
78| |
79| | Set Test Variable | \${frame_size}
80| |
81| | Given Set Max Rate And Jumbo
82| | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
83| | And Pre-initialize layer driver | ${nic_driver}
84| | And Apply startup configuration on all VPP DUTs
85| | When Initialize layer driver | ${nic_driver}
86| | And Initialize layer interface
87| | And Initialize IPv4 forwarding with vhost in 3-node circular topology
88| | ... | nf_nodes=${nf_nodes} | testpmd_mac=${TRUE}
89| | And Configure chains of NFs connected via vhost-user
90| | ... | nf_chains=${nf_chains} | nf_nodes=${nf_nodes} | jumbo=${jumbo}
91| | ... | use_tuned_cfs=${False} | auto_scale=${True} | vnf=testpmd_mac
92| | Then Find NDR and PDR intervals using optimized search
93
94*** Test Cases ***
95| tc01-64B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
96| | [Tags] | 64B | 1C
97| | frame_size=${64} | phy_cores=${1}
98
99| tc02-64B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
100| | [Tags] | 64B | 2C
101| | frame_size=${64} | phy_cores=${2}
102
103| tc03-64B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
104| | [Tags] | 64B | 4C
105| | frame_size=${64} | phy_cores=${4}
106
107| tc04-1518B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
108| | [Tags] | 1518B | 1C
109| | frame_size=${1518} | phy_cores=${1}
110
111| tc05-1518B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
112| | [Tags] | 1518B | 2C
113| | frame_size=${1518} | phy_cores=${2}
114
115| tc06-1518B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
116| | [Tags] | 1518B | 4C
117| | frame_size=${1518} | phy_cores=${4}
118
119| tc07-9000B-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
120| | [Tags] | 9000B | 1C
121| | frame_size=${9000} | phy_cores=${1}
122
123| tc08-9000B-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
124| | [Tags] | 9000B | 2C
125| | frame_size=${9000} | phy_cores=${2}
126
127| tc09-9000B-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
128| | [Tags] | 9000B | 4C
129| | frame_size=${9000} | phy_cores=${4}
130
131| tc10-IMIX-1c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
132| | [Tags] | IMIX | 1C
133| | frame_size=IMIX_v4_1 | phy_cores=${1}
134
135| tc11-IMIX-2c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
136| | [Tags] | IMIX | 2C
137| | frame_size=IMIX_v4_1 | phy_cores=${2}
138
139| tc12-IMIX-4c-ethip4-ip4base-eth-2vhostvr1024-1vm-ndrpdr
140| | [Tags] | IMIX | 4C
141| | frame_size=IMIX_v4_1 | phy_cores=${4}
142